Skip to content

Zoom camera#

The Zoom camera animation provides a zoom effect by modifying only the camera's position between the start and end frames but leaving the target point unchanged. This is useful if you just want to zoom on a part of a system without, for example, changing target points for the Fog and Depth-of-field special effects. Compare it to the Dolly camera animation which can have different target points for the start and end frames.

See also: Move camera animation.

Adding the animation#

First, choose the start frame in the Animator's Track view and orient the view/camera as you would like it to be positioned.

Then, double-click on the Zoom camera animation effect in the Animation panel of the Animator.

Set the end frame of the animation as needed.


You can always move the start and end frames of the animation.


By default, camera animations are applied to the active camera (to change that, inspect the animation and modify the "Apply to active camera" option). So, the target point of the animation will be defined as the current target position of the active camera, which is basically the current center of the view.

The camera positions might be defined differently whether you have the grid in the switched on or off. To change how the animation behaves depending on whether the grid is on or off, inspect the animation and modify the "Keep camera upwards" option - if this option is checked then it will depend on whether the grid is on or off.

You can also change how the camera's parameters are interpolated between the frames by modifying the Easing curve.

Adjusting camera positions#

You can adjust the camera's target point and positions using the animation controllers. See Adjusting camera positions.